Profine Gold Medium Ultrafiltration Filter – 10,000lt. COD: CL-330346

0.5 micron antimicrobial carbon block filtration with final 0.1 micron ultrafiltration (UF) stage.
Absolute broad-spectrum barrier against bacteria.

Profine® GOLD eliminates unwanted odors and flavors. The quick-connect cartridge is a disposable type made with extruded carbon block technology with added silver to perform a bacteriostatic action with a final UF Ultrafiltration membrane capable of removing 99.99999% of bacteria. Composite structure cartridge suitable for the treatment of drinking water in compliance with DM 25/2012.

Removes bad taste and odor, chlorine, dirt, rust, suspended matter not visible to the naked eye, mold and algae. Reduction of aluminum, ammonium (NH4), iron and sulfate.

* Ideal for drinking and cooking in maximum safety.
* Improves the taste of beverages, sparkling water and post-mix systems.
* Protects against blockages, corrosion and wear.
* Does not require electricity.
* Vertical or horizontal installation, it doesn't matter.
* The quick cartridge is easy to install and replace without the use of special tools.

The Profine GOLD range together with antimicrobial protection slows down the possible proliferation of bacteria.

Characteristics:
* Chlorine reduction
* Bacteriostatic
* Reduction of bacteria and viruses
* Reduction of suspended particulate matter

• Technology: Multistage, Carbon Block (CB) with Ultrafiltration (UF)
• Filter density: 0.1 micron
• Autonomy: Depending on the model, see table.
** Autonomy varies according to:
* of the quality of the incoming water
* of the required capacity
* of the incoming water pressure
* of the use of the filter (continuous or intermittent)

• Cartridge dimensions: HxD (mm.) SMALL 269×87.4(mm.) – 10.59”x3.44″(In.)
• Cartridge dimensions: HxD (mm.) MEDIUM 384×87.4(mm.) – 15.11”x3.44″(In.)
• Cartridge dimensions: HxD (mm.) LARGE 529×87.4(mm.) – 20.82”x3.44″(In.)
(Leave a vertical space of approximately 7 cm under the cartridge to allow for replacement.)
• Activation: it is advisable to let the water flow through the filter at maximum pressure and with maximum flow rate, for at least 5 minutes to allow the air present in the filter to be purged.
• Cartridge change: When capacity is reached, or when flow is too slow (falls below 0.7bar/10psi), every 6 months but at least annually.