Profine Arsenic Medium Filter – 15,000lt. CODE: CL-330518

Reduces arsenic concentration in drinking water. 0.5 micron antimicrobial carbon block filtration with arsenic selective resin mixed with activated carbon.
Profine® ARSENIC eliminates unwanted odors and flavors. The quick-connect cartridge is a disposable type made with extruded carbon block technology added with silver to perform the bacteriostatic action.

Removes bad taste and odor, chlorine, dirt, rust, suspended material not visible to the naked eye, mold and algae. Reduction of arsenic (type “III” trivalent and “V” Pentavalent) where it exceeds the potability limits. It is a disposable cartridge suitable for the treatment of drinking water. Resin compliant with NSF 61 and WRAS standards, remaining components in contact with water compliant with DM 174/2004. For drinking water with arsenic concentration 10 µg/l.
The performance of the Profine Arsenic Free cartridge is not affected by other unwanted substances; the arsenic once retained will not be released in any way, thus ensuring the highest quality.

• Ideal for drinking and cooking in maximum safety.
• Improves the taste of beverages, sparkling water and post-mix systems.
• Protects against blockages, corrosion and wear.
• Does not require electricity.
• Vertical installation with “R” model head
• The quick cartridge is easy to install and replace without the use of special tools.

The Profine ARSENIC range together with antimicrobial protection slows down the possible proliferation of bacteria.

Characteristics:
• Chlorine reduction
• Reduction of arsenic
• Bacteriostatic
• Reduction of suspended particulate matter

• Technology: Multistage, Carbon Block(CB)
• Filter density: 0.5 microns
• Autonomy: Depending on the model, see table.
– Autonomy varies according to:
• the quality of the incoming water
• of the required capacity
• of the incoming water pressure
• filter use (continuous or intermittent)

• Cartridge dimensions: HxD (mm.) SMALL 269×87.4(mm.) – 10.59”x3.44″(In.)
• Cartridge dimensions: HxD (mm.) MEDIUM 384×87.4(mm.) – 15.11”x3.44″(In.)
• Cartridge dimensions: HxD (mm.) LARGE 529×87.4(mm.) – 20.82”x3.44″(In.)
(Leave a vertical space of approximately 7 cm under the cartridge to allow for replacement.)
• Activation: It is advisable to let the water flow through the filter at maximum pressure and with maximum flow rate, for at least 5 minutes to allow the air present in the filter to be purged.
• Changing cartridges: When capacity has reached, or when flow is too slow (falls below 0.7bar/10psi), every 6 months but at least annually.

Do not use where water is microbiologically unsafe or of unknown quality without adequate disinfection before and after the system. Systems certified for contaminant reduction may be used on disinfected water that may contain filterable contaminants. All systems must be maintained according to the manufacturer's instructions.
Note: The pollutants removed or reduced by this system are not necessarily in your water.