Clack Electronic Double Body Water Softener 75lt. Resin – for 18/20 People COD: CD-1500020375X

75 Liters Resin Double Body (Suitable for 18/20 People)

Remove Limescale from Water Forever!

Clack WS1CI 1” automatic electronic valve Volume/time regeneration. Low water and salt consumption for each regeneration. Valve body in Noryl plastic material, NSF listed. Simple programming, time entry, day of the week entry, regeneration time, usually 02.00 at night, Number of days between regenerations and input hardness. Complete with 12/230V – 50Hz European plug power supply socket. Output hardness regulator. An output hardness of around 15°F is recommended, however the most frequently used regulation is not less than 5°F. Loosening the adjustment screw will allow the mixing with raw water to be reduced at the output. To mix a specific output hardness value, adjust the screw and test the water. Repeat the procedure until the desired hardness value is reached.

TO BE PURCHASE WITH EVERY WATER SOFTENER
1x Clack WS1/WS1TC Bypass Valve
1x Standard 3-piece container 10" transparent IN-OUT 1" with key and bracket
2x Ionicore Cartridge Polypropylene Wrapped 9-3/4" - 50 micron
1x Titrant Kit total hardness (1°F) single reagent 15cc.
* Water softeners are supplied without salt, it is recommended to use salt tablets.

The device is supplied programmed with an inlet hardness of 40°F, an outlet hardness of 0°F and a safety regeneration every 7 days. The bypass valve (if ordered) isolates the device from the water system to allow the use of untreated water. Routine maintenance or service may also require the system to be placed in bypass.

Characteristics
* Simple and intuitive programming
* Solid state microprocessor with front panel settings.
* Large LCD display.
* 48 hours internal power backup.
* Real time of the day expressed in hours and minutes.
* Residual volume of softened water.
* Display of regeneration phases and remaining cycle time.
* Quick and easy setup of regeneration capacity, time and day.
* The set programming remains in memory and will not be lost in the event of power failures.
* Step-by-step electronic regeneration.
* Manual, delayed or immediate regeneration.
* Low salt alarm.

* Min. pressure: 1.4bar(1.4kg/cm2)
* Max. pressure: 8.6bar(8.6kg/cm2)
* Minimum temperature: 4°C
* Max temperature: 43°C
* Water inlet/outlet 1" male thread
* Exhaust: hose connection with 2m of pipe
* Overflow: 3/8" hose connection

Model Specifications
* Exchange capacity: 375ºHFxm3.
* Salt consumption for regeneration: 9.75 Kg./salt.
* Water consumption for regeneration: 525lt.
* Quantity of water treated for regeneration, 30°F-12.50m3, 35°F-10.71m3, 40°F-9.37m3, 45°F-8.33m3, 50°F-7.50m3, 60°F-6.25m3.
* Max. flow rate 2.63m3/h
* In the double block the cylinders are supplied full up to the 40lt version.